Generally speaking, when the shop is decorating, there is already a plan to install the EAS antennas. Therefore, the decoration company will reserve the wiring position of anti-theft device during this time, so that when the anti-theft devices need to be installed, customers can complete in one step!

Also some shop owners did not have the idea of installing EAS systems during the decoration. But in the later store management, the shop owners think EAS devices are needed. However, at this time, the decoration company has already laid the floor. So in this case, if EAS system still can be installed? If yes, how can the store's decoration not be affected as much as possible?

As everybody knows, the beauty of the store directly affects the experience store that customers enter the store. Only the smallest changes can ensure the original integrity of stores. First of all, EAS systems can still be installed in decorated shops. And the best way is to use the installation method of grooving, which means to cut a channel that can hide the connecting cable under the floor between two antennas. Using this method, only slight changes need to be made at the store entrance, which will not affect the beauty of the store.

EMENO Installation Steps of Grooving:

1. Unscrew the base cover with a screwdriver

2. Tighten each port of 9PIN and 5PIN wires

3. Power on and do the detection

4. Mark the location of antenna installation and grooving

5. Drilling holes and cutting grooves

6. Remove tile strip and fixed expansion screw

7. Fix the gap with sand and hide 5PIN and 9PIN wire in it

8. Tighten the screws to hold the device

9. Wiring and power on

10. Cover the base